Initial Setup of NetWeaver ABAP System – verification

Let the world know ...Tweet about this on TwitterShare on Google+0Share on Facebook1Email this to someoneShare on LinkedIn0

After running the initial setup task, you might want to know if your system is actually OK. Instead of checking parameters manually, you can also make use of the task wizard. A task list named SAP_BASIS_SYSTEM_CONFIG_CHECK is available that runs a set of tests against your configuration.

Transaction: STC01

Task list: SAP_BASIS_SYSTEM_CONFIG_CHECK

Check the validation tasks you want to execute.

Execute the verification

Result

For each warning or error, you can access the log message to understand why the task failed.

If you want, you can include this task in your daily work routine.

Let the world know ...Tweet about this on TwitterShare on Google+0Share on Facebook1Email this to someoneShare on LinkedIn0

One thought on “Initial Setup of NetWeaver ABAP System – verification

  1. Pingback: Install your own SAP NetWeaver ABAP system | It`s full of stars!

Leave a Reply

Your email address will not be published. Required fields are marked *